Family Health Screening Test Liver, Kidney, UTI, Diabetes & more – 6 Testing Strips

For full instructions on how to use this product click here.

Instructions

A urine sample must be collected in a clean and dry container and tested as soon as possible. If testing cannot be done within an hour, refrigerate the specimen immediately and let it return to room temperature before testing.

Do not store urine at room temperature for longer than one hour as test results may be unreliable.

Do not contaminate the urine sample with skin cleansers containing chlorhexidine as this may affect test results.

• Remove the strip from the sealed pouch, and use it as soon as possible.
• Hold the end of the strip farthest away from the test pads.  Dip the test pads of the strip completely into fresh urine for 1-2 seconds and remove immediately.  Run the edge of the strip against the rim of the urine container to remove excess urine (see illustration 1).
• After removing the strip from your urine, immediately bring the edge of the strip into contact with an absorbent material (e.g. paper towel).  Lay the strip with the test pad(s) facing upwards and begin timing (see illustration 2).
• Read results.  After the specified times shown on the colour chart, compare the colour of the test pads with the colour blocks on the colour chart. Hold the strip close to the colour blocks and match carefully (see illustration 3).

Note:  Results may be read up to 2 minutes after the specified times.

Results are obtained and interpreted by comparing the colour of the test pads on the strip with the colour blocks printed on the colour chart.  In the event of unexpected or questionable results, confirm that the strips have been used before the expiry date printed on the pack then repeat the test using a new strip.

If the results are outside the normal levels (see below), consult your doctor.

Nitrite: Any degree of uniform pink to red colour should be interpreted as a positive result and you should consult your doctor.  Viewing the test against a white background may help the detection of low levels of nitrite, which might otherwise be missed.  Pink spots or pink edges should not be interpreted as a positive result.

Protein: If your result is 30mg/dL (0.3g/L) or more, consult your doctor.

Urobilinogen: All results lower than 1 mg/dL urobilinogen should be interpreted as normal. If your result is 2mg/dL (35mmol/L) or more, consult your doctor.

Blood: A positive (+) result may be seen as either a uniform colour change of the test pad or the appearance of green spots on the test pad (see colour chart).  If either type of positive result is obtained, consult your doctor.
Note:  Strenuous exercise can cause blood to appear in urine and blood is often found in the urine of menstruating women. A uniform colour change indicates the presence of haemoglobin or broken red blood cells in the urine.Green spots on the test pad indicate the presence of intact red blood cells (erythrocytes)

Specific Gravity: A single low reading or a single high reading does not indicate a problem (see Principle and Expected Values).  However, persistent low or high readings over a period of time should be checked by your doctor.  High protein levels in urine (more than 300mg/dL) can cause high specific gravity results.

Bilirubin: Bilirubin is absent in normal urine, so any positive result should be investigated further by your doctor.  If you are taking drugs containing chlorpromazine or rifampen, colour reactions may occur on the test pad that might be mistaken for positive bilirubin.